Aircraft Pu Hose Fitting Elbow 6Mm-3/8 F

AirCraft PU Hose Fitting Elbow 6mm-3/8" F BSP

At a Glance: 6mm push-in to 3/8" female BSP elbowâ"clean 90° routing with a larger threaded connection.

When you need compact 90-degree hose routing but a larger threaded port, the AirCraft PU Hose Fitting Elbow 6mm-3/8" F BSP delivers a neat and reliable connection. It accepts 6mm PU tubing via a quick push-in fitting and mates to compatible pneumatic components using a 3/8" female BSP thread. Ideal for compressed-air plumbing, pneumatic panels, manifolds, regulators and valves, this elbow design helps prevent kinks, reduces strain on tubing, and keeps your setup organisedâ"especially where space is limited and hose runs need to behave.

Specifications

Features

• Push-in tube connection Tool-free installation with 6mm PU tubing.
• 90° elbow body Supports neat hose routing and helps avoid tight bends.
• 3/8" Female BSP thread Suits compatible BSP pneumatic ports and adapters.
• Compact, practical design Fits well in tight assemblies while keeping lines controlled.
• Reliable sealing interface Designed for consistent service in normal pneumatic applications.

Benefits

• Cleaner system layout: Keeps tubing runs tidy and improves access around components.
• Reduced tubing stress: Minimises kinks and strain, helping extend tubing life.
• Quicker servicing: Push-in convenience makes tube changes fast and straightforward.

Extra Information

• Use with 6mm outer-diameter PU tubingcut the tubing square and insert fully until it seats.
• Confirm the BSP thread standard and the required sealing method for the threaded side depending on the mating component.
• To remove the tube, depress the collet evenly and pull the tubing straight out to avoid damaging the end.

Safety

• Wear eye, ear and dust protection where applicable when working around pressurised air systems.
• Depressurise the system completely before installing, removing, or servicing pneumatic fittings.
• Check for leaks after installation using a suitable leak-detection method and re-check after initial operation.
• Ensure tubing is correctly sized, fully seated, and all connected components are compatible before pressurising.