Aircraft Pu Hose Fitting Elbow 8Mm-1/2 F

AirCraft PU Hose Fitting Elbow 8mm-1/2" F BSP

At a Glance: 8mm push-in to 1/2" female BSP elbowâ"compact 90° routing with a larger threaded connection.

For a tidy corner turn and a larger threaded connection, the AirCraft PU Hose Fitting Elbow 8mm-1/2" F BSP is a practical, reliable connector for compressed-air and pneumatic systems. The push-in side accepts 8mm PU tubing for fast, clean installation, while the 1/2" female BSP thread connects to compatible ports and adapters on manifolds, regulators, valves and pneumatic panels. The 90-degree elbow layout helps prevent kinks, reduces strain on tubing and ports, and keeps your hose runs controlledâ"especially in tight spaces where straight fittings would fight back.

Specifications

Features

• Push-in tube connection Tool-free installation with 8mm PU tubing.
• 90° elbow design Helps avoid tight bends and supports tidy hose routing.
• 1/2" Female BSP thread Suits compatible BSP pneumatic ports and adapters.
• Compact body Fits well in tight assemblies while keeping line runs controlled.
• Reliable sealing interface Designed for consistent performance in normal pneumatic applications.

Benefits

• Cleaner system layout: Keeps tubing runs neat and improves access around components.
• Reduced tubing stress: Minimises strain, helping reduce kinks and premature tubing wear.
• Faster maintenance: Push-in convenience makes servicing and tube changes quicker.

Extra Information

• Use with 8mm outer-diameter PU tubingcut the tube square and insert fully until it seats.
• Confirm the BSP thread standard and sealing method required for the threaded side depending on the mating component.
• To remove the tube, depress the collet evenly and pull the tubing straight out to avoid damaging the tube end.

Safety

• Wear eye, ear and dust protection where applicable when working around pressurised air systems.
• Depressurise the system completely before installing, removing, or servicing pneumatic fittings.
• Test for leaks after installation using a suitable leak-detection method and re-check after initial operation.
• Ensure tubing is correctly sized, fully seated, and all connected components are compatible before pressurising.