AIYI - Electric Soldering Iron

(PRELOVE LOVED PRODUCT, FLUX IS HARD, THE ITEM HAS BEEN USED, IT DOESNT REALLY GET HARD) 

Use References:
1. The applicable voltage for this appliance is AC 220-240V.Please check that the voltage on the product rating plate coincides with your mains voltage.
2. Do not use the appliance under any circumstances in areas with explosive or caustic gases.
3. Do not rap the appliance since the current is switched on. The operational life span will shorten due to short heating wires.
4. Normal electronics-grade solder is usually rosin or tin solder paste. Especially when the power is under 100W, a solder stick will be the first choice. Hydrochloric acid is not appropriate for use as solder. Heat evaporates acid fluxes, which might cause some internal components to corrode and lead to the damage to the appliance.
5. If the copper board is notoriously difficult to solder, use a small hand-held file or perhaps scrape a knife blade over it to reveal fresh metal underneath.
6. Take off the copper tip and remove the layer of oxidation. Do this immediately, with new tips being used for the first three times ,in order to avoid tips that cannot be lifted down after being used for a long time.
7. Do not use the appliance during wet or wet operations. Keep away from moisture to prevent short circuits.
8. This appliance fits a grounded receptacle only.
9. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities or a lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.