Arc / T Corner Radius Quick Jig Router Trimming Corner Gauge Aluminum Alloy Angle Locator Template W

New

20 available

R763.00

Add to watchlist Watch

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou4038

92.40 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Product details

Condition

New

Location

International

Bob Shop ID

654092131

Feature	-Can be processed in batches, so that every corner can become a standard part. -Quickly replace the screws, so that the processing is more labor-saving and labor-saving.
Specification	Brand new & High Quality Type: Router Jig Material: Aluminum alloy 6061 Surface treatment: anodic oxidation (non paint)
Steps for usage	(1) Loosen the middle copper screw, adjust it to the required corner, and tighten the screw. Place it on the wooden board and hold the protrusion above the chamfering module, close to the wooden board, and keep your hands away from the cutter. (2) After sticking tightly, bring the wooden board close to the cutter and cut the sharp end of the wooden board into a rough shape, and then walk it slowly by the side of the module.
Precaution	- It should be used on workbenches such as flip-chip electric milling. - A trimming knife with a bearing on the top should be used. - The height of the milling cutter must be adjusted before use. When the machine is not turned on, observe whether the milling cutter bearing and the fillet module are on the same plane to ensure that the milling cutter will not scratch the module, otherwise it may cause danger. - The solid wood should be cut from left to right along the grain of the wood, not upside-grain milling.
Package included	1x Set Template