Arduino Dedicated Sensor Shield UNO MEGA DUEMILANOVE

New

20 were available

R79.00

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

MakerTree32

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Customer ratings:

1 ratings

Bob Shop ID

157910050

Brand new dedicated Sensor Shield for Arduino

Here we have a brand new Arduino sensor shield V4.0.

This shield can easily connect your Arduino to many frequently used sensor and circuit modules. You can connect Arduino compatible boards easily with various digital, analog and I2C/Uart interfaces without lots of messy wiring.

Each pin has both a Male and a Female header, so no matter which you have on your sensor, there is somewhere to connect it. If you have 3-pin (Power, Ground, Signal) sensors or servos then each pin also has the correct terminals for that.

If that isn't enough, there are also locking 3-pin terminals/connectors for sensors with suitable connectors