The latest in Airsoft battery technology. Li-Fe has a longer life cycle, as well as better thermal performance, (good performance in high and low temperature) than a Li-Po battery does. During use in airsoft guns, thermal stability is very important, and many batteries can get too hot to safely use.
The 9.9 Li-Fe battery also strikes a perfect balance for high performance in AEGs below 1 joule energy output. For most standard Airsoft guns, an 11.1V battery has too high a voltage for the motors and the gears and can potentially damage the gun. A 9.9V Li-Fe has perfect voltage for high performance Airsoft guns while maintaining a rapid rate of fire. This battery is fitted with T-Plug connectors for more efficient power transfer.
Important: A Li-Fe charger must be used, we recommend following the Auto-stop LiPo Life.
Battery specs:
Configuration: 3 split-cell.
Fitted with T-Plug connectors
Voltage: 9.9V.
Capacity : 1000mAh.
Comes with align balance connector.
Dimensions: 126mm x 20mm x 6.5mm per cell
Size compatible with mini-type batteries.
This pack is ideal for M90 to M120 upgrades.
Replaces an 8.4V to 9.6V NiMH pack.
Ultra-advanced Li-Fe battery technology.
To prolong the life of a Li-Fe battery:
Never completely discharge the battery.
Stop using the battery the moment you hear the Rate of Fire goes down.
IMPORTANT: You must use a Li-Fe charger, no exceptions.
WARNINGS
Only use approved LiFe chargers and never use a NiMH or NiCd charger to charge LiFe
Do not pierce the battery
Do not disassemble the battery
Do not short-circuit the battery terminals
Do not connect the battery directly to an electrical outlet
Do not strike or throw the battery against hard surfaces
Do not immerse the battery in water or seawater
Always disconnect the battery immediately after use, charging or discharging and keep the battery in a cool, dry environment during standby periods
Do not use, throw or leave the battery near heat source such as fire or heater
Do not dispose of the battery in fire or heat
The battery should not be charged with more than a current of 1C (e.g. a 1200 mAh battery should be charged with 1.2 A (1200 mA)). Charging with higher currents can potentially damage battery cells or even lead to overheating or other serious failures
Stop charging immediately if temperature exceeds 45°C
Stop using battery if temperature exceeds 60°C
Never leave LiFe batteries charging unattended
Always monitor the charging process of your LiFe batteries so that you can react immediately to any potential problems
If your LiFe batteries start to balloon or swell up, discontinue charging/discharging/usage
Before and after use of your LiFe batteries, inspect them to ensure that there is no physical damage or swelling as those are signs of imminent failure
