Auto Leveling Position Sensor Kit for Anet A8 Prusa i3 3D Printer
New
501 were available
Indicative market price:
R695.50
R417.30
40% off
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 3 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
Adoption of high quality material, it is durable and long lasting use. It works well with Anet A8 3D printer.Pretty solution for auto-adjusting heatbed level, convenient for use. Comes withmounting plate and pre soldered connector so no wiring is needed. Just unplug the original z stop and plug in sensor and screw into the back of printer.
Feature
- Color: As shown. - Material: Plastic and metal. - Package size: About 10 x 10 x 3cm/3.9 x 3.9 x 1.2inch(LxWxH). - Detect range: 5mm. - Working voltage: DC 10-30V. - Output method: NPN three wire normally open. - Current: 300mAh. - Adoption of high quality material, it is durable and long lasting use. - Works well with Anet A8 3D printer. - Pretty solution for auto-adjusting heatbed level, convenient for use. - Comes withmounting plate and pre soldered connector so no wiring is needed. Just unplug the original z stop and plug in sensor and screw into the back of printer.
