Battery Adapter For Worx 6pin with 6FT Jumper Cable Clamp Battery Jumper Starter

Product Description Compatible With Worx 20V 6PIN Li-ion BatteriesWork with for Worx 20V 6PIN L i-ion Battery. Like WA3525, WA3578, WA3575, WA3520, WG151s, WG155s, WG251s etc. ( N o t for 4 PI N Series,Not for 5PIN Seriesplease note )Easy to install ,locks on you battery very well.(Notice:Battery not included) FeaturesAdapter is crafted from tough ABS plastic, built to withstand the rigors of frequent use. The adapter itself is forged from pure cooper, enhancing both electrical conductivity and safety measures. The non-conducting rubber and dual-grip design ensure superior contact and secure tension.Wire cable: 12AWG, Wire harness length: 6ft How to use1.Connect the red battery clip of the jumper cable to the positive pole (+) of the vehicle and the black to the negative pole (-)2.Plug the jumper into the jumper starter socket; 3.Start the car and disassemble Lower clamp. (Please follow the correct steps after reading the instructions for use). Safety PrecautionsDo NOT reverse the operation sequence of the jump starter. Please be careful when using this product, this item can NOT be overloaded, check your device power before using, please. Do remove the product from the vehicle within 30 seconds after the vehicle is started, or it may cause security incidents. Note: Always check if your power bank is capable of supporting your car. KEEP IN MIND, the jump starter doesn't convert voltage/ Step-down voltage! NoteDue to the light and monitor difference,the item's color may be slightly different from the pictures. Please allow 1 inch differs due to manual measurement,thank you for your understanding! Note:Battery not i ncluded