Battery Li-ion 18650 Charger Micro USB 5V 1A with Overcharge Protection:
Specifications:
Current: 1A adjustable.
Charge precision: 1.5%.
Input voltage: 4.5V-5.5V.
Full charge voltage: 4.2V
Input interface: micro USB.
Work temperature: -10deg to +85deg
Size: 27 x 17 x 4m
Led indicator: red is charging. Blue light is full charged. Blue light with red flashing indicates connection issue.
Reversed polarity: NO. Do not connect + and - incorrectly as the unit will get damaged.
Note:
1. Ampere meter can only be connected to 5v input end of the module.
2. It is better that the charging current is 37% of the battery capacity. If you charge to the battery of 1000mAH, current of 400 is enough.
3. The connection wire should not be too thick.
4. Make sure the connect point is good.
5. If the input voltage is too high, like 5.2v, the current will be less than 1000mA, it is normal. It is protection function, auto-substract the charging current to avoid burn damage to chip.
6. NO Reverse polarity
Please choose and search using the undermentioned keywords/products in our store:
Aquarium, Aluminium, Ammeter, Adhesive, Adapter, Amp, Battery, Bicycle, Box, Cable, Conductive, Cob, Car, Chip, Circuit, Cooling, Clamps, Clips, Cover, Constant Current, Channel, DC, Dimmer, Enclosure, Charger, Controller, Connector, Cree, Dimmer, Driver, Enclosure, Fan, Floodlight, Float, Female, Flashlight, Holder, Hydroponic, Heatsink, Heat, Joiner, Level, Lens, Led, 5mm, 1W, 3W, 5W, 10W, 20W, 30W, Grow Light, 50W, 100W, Li-ion, Light, Meter, Male, Module, Motorcycle, Motor, Probe, PWM, Power, Parallel, Panel, Plate, Peltier, Plaster, Plug, Pump, Regulator, Reflector, Relay, Remote, RGB, Rigid, Series, Signal, Shunt, Sensor, Spectrum, Sleeving,Silicone, Solar, Strip, Speed, Solder, Step Up, Solder, Step Down, Strip, Switch, Tape, Time, Terminal, Temperature, Thermostat, Thermal, Tool, USB, Vehicle, Wire, 3.7V, 5V, 9V, 12V, 24V, 220V, Volt, Voltmeter, Waterproof, Wire, Watt, Wireless
Please see all our listings here:
www.bidorbuy.co.za/seller/434337/Led_Select
