Bearing Gear Puller, Pinion Puller Removal Tool, for Rc Motor Parts
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
613386960
Install the gear lever into rotation bracket and fitted swim boards.Choose the thimble you need to pull,plug in the rotation lever,tighten the screws (Note:There are thimbles with platform, screws should not too tight).Snapping the motor into the swimming board, and move to pull the motor shaft aligned thimble.Includes 5 pins for motor shaft diameter 0.9mm*1,1.75mm*2,1.9mm*1,2.8mm*1, suitable for motors of rc helicopter, plane or servo.Rotates active lever as clockwise, pull out the motor gear.Colour: silverMaterial: ironPackage Contents:1 * Motor Pinion Gear Puller Remover Tools SetOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.