BESTEP 6 Channel 12V Relay Module Low Level Trigger With Optocoupler Isolation
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615104458
Description: ? Maximum load: AC 250V/10A, DC 30V/10A. The chip optocoupler isolation, strong driving ability, stable performance, trigger current 5mA. Working voltage is 12V. Each channel of the module can be set up by high jumper or low level trigger. Fault tolerant design, even if the control line is broken, the relay will not act. Power indicator (green), 6 relay status indicator (red). The interface design is humanized, all interfaces can be directly connected through the terminals, so it is very convenient. Module size:?142mm x 50mm x 18.5mm (length x width x height). There are 4 fixed bolt holes, holes 3.1mm, spacing 67mm x 44.5mm.
Module interface: ? 1. DC+: Connect the power positive pole 2. DC-: Connect the power negative pole. 3. IN1-IN6:?According to the setting of each way, the corresponding?relay-operating?can be controlled by high or low level. ? Relay output: there is a 18 wire interface, all interfaces can be directly connected to lead to facilitate user use. ? 1. NO1--NO6: Relay normal open, the relay suspends before pulling in, and then short-connect with the COM. 2. COM1--COM6: Relay common interface 3. NC1--NC6: Relay normal close,?short connected with COM before?pulling inand suspended after?pulling in. ? High and low level trigger option:
1. S1-S6 is the high level trigger selection of relay 1 Channel - 6 Channel. 2.?When COM is short connected with LOW, the corresponding relay is LOW level trigger, while when COM is short connected with high end is high level trigger. ? Package Included:
1 x 6 Channel 12V Relay Module
Module interface: ? 1. DC+: Connect the power positive pole 2. DC-: Connect the power negative pole. 3. IN1-IN6:?According to the setting of each way, the corresponding?relay-operating?can be controlled by high or low level. ? Relay output: there is a 18 wire interface, all interfaces can be directly connected to lead to facilitate user use. ? 1. NO1--NO6: Relay normal open, the relay suspends before pulling in, and then short-connect with the COM. 2. COM1--COM6: Relay common interface 3. NC1--NC6: Relay normal close,?short connected with COM before?pulling inand suspended after?pulling in. ? High and low level trigger option:
1. S1-S6 is the high level trigger selection of relay 1 Channel - 6 Channel. 2.?When COM is short connected with LOW, the corresponding relay is LOW level trigger, while when COM is short connected with high end is high level trigger. ? Package Included:
1 x 6 Channel 12V Relay Module