Bicycle Indicator Brake Light Set (also for scooters and motorbike)
1 was
available
/ new
Indicative market price: R400
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Bob Shop ID
53010288
Bicycle Indicator Brake Light Set
Make cycling much more safer!!!
Features:
- Left / right directional control switches
- 11 super bright LED
- 8-tune Horn: An integration of the 8-sound horn
- Light Model: Turning light, break light, night lamp
- Keeping your safety in the darkness and early morning
- Ideal for outdoor activities, like biking / hiking
- Lowest power consumption
- Also can be used for scooters and motorbike
Specification:
- Powered by two AA batteries(not included)
- Dimensions of the Turning LED Light (L x W x H): 130 x 60 x 55 mm (5.12 x 2.4 x 2.2 inch)
- Dimensions of the Horn (L x W x H): 80 x 60 x 33 mm (3.15 x 2.4 x 1.3 inch)
- Control Wire Length:
(Horn & main switch -- turn signal light: 135cm / 53.15 inch )
(Break switch -- turn signal light: 68cm / 26.78 inch )
Make cycling much more safer!!!
How does it work and how to install?
- Then controller should be installed on the handle bar, pull the on-off key to the "L" position, the yellow light on the left side will be flashing. When the switch is at the "R" position, the yellow light on the right side will be flashing. When the night mode switch is on, the red light on the front and the tail light will be on to ensure safety when riding.
- The brake light sensor should be installed on the rear brake: Open the rear brake box, make the brake cable go through the sensor head and fasten it, then the sensor is finally installed on the rear brake
PLEASE HAVE A LOOK AT SOME OTHER ITEMS I'M SELLING
http://www.bidorbuy.co.za/seller/1271723/monkeey