Name: Black - B-CUBE Storm32 BGC 32-Bit 3-Axis Brushless Gimbal Controller DRV8313 Driver 9-18V For RC Gim
SKU: 2048763-POA12290484
Price: 1047.23 ZAR
Availability: InStock

Black - B-CUBE Storm32 BGC 32-Bit 3-Axis Brushless Gimbal Controller DRV8313 Driver 9-18V For RC Gim

New

1 available

Indicative market price: R1,580.05

Only 1 left – grab it before it’s gone!

R1,047.23

34% off

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

There are various locker and counter collection points across South Africa.
View locations

The seller has indicated that they will usually have this item ready to ship within 15 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

The World OnLine10362

95.68 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

2048763-POA12290484

Bob Shop ID

678780778

Feature:
- Processor: STM32F103RC at 72Mhz
- Motor driver: DRV8313 with short circuit, overheat protection
- Onboard gyro and acceleration sensor MPU6050
- IR LED Interface
- Futabaa S-BUS
- Spektrum satellitee port
- 7CH PWM/Sum-PPM input/output
- Each axis could connect analog joystick
- With I2C port, could use external 6050 to replace onboard sensor
- 3* AUX port

Specifications:
Item Name: Storm32 BGC 32-bit 3-axis Brushless Gimbal Controller
Hardware : Storm32BGC
Hardware Version: V1.32
Firmware: o323bgc-release-v096
Power supply: 9-18V(3-4S)
Drive current: Max.1.5A
Dimension: 5-5cm, M3 screw hole, 45mm pitch
Weight: 10g

How to install:
1. Remove vibration ball, open at the mounting plate.
2. Lock mounting plate with screws at the bottom of the craft.
3. Install the shock absorber ball.
4. Install the camerawith a belt style compact camera.

Note:
Install the camera (be sure to install the camera properly, otherwise it will shake), power on the gimbal and stabilize it for above 30 seconds ,do not shake the gimbal, keep it hanging,do not touch the camera with hands, keep it suspended. After hearing the sound, it can be used normally.

Package included:
1 x Strom32 3-Axis gimbal controller DRV8313 Driver
1 x Sensor