Main centres: | 1-3 business days |
Regional areas: | 3-4 business days |
Remote areas: | 3-5 business days |
Applications
Method of use
Substrates should be clean, firm, dry and free of dust and grease. Substrates can be cleaned with Simson Cleaner E. Keep the packaging well closed until the moment of use. Do not use Prep P direct from the original packaging. Pour as much Prep P into a clean glass or tin as can be used within 30 minutes and immediately close the original tin firmly. Always use a clean brush for the application of Prep P. Apply Prep P to the adhesion surface only in such a way, that Prep P forms a continuous coat or film. Prep P should be applied in a thin coat. Do not apply Prep P on already dried product. The application temperature can vary from +5C till +30C. The minimum drying time of Prep P is 60 minutes. Best results are obtained when the bonding/sealing is realised within 6 hours after applying Prep P. Therefore do not apply more Prep P than can be sealed within 6 hours. Avoid contact with the cleaned and pretreated surfaces because greasy fingers can cause bad adhesion. Also, condensation can negatively influence the adhesion. It is not recommended to use Prep P and to seal the joints during very high air humidity, for example during fog.
Coverage
The coverage depends on the type of substrate and will be between 8 - 10 m2 per liter.
Storage stability
Prep P can be stored for 12 months in an original, unopened container in a dry place at temperatures between +5C and +30C.