Brass Shims for guitar necks - Set of 4
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Capri, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Friday, 17 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
Id-5362
Bob Shop ID
569934786
4 x Brass shims of various thicknesses to get the perfect angle on your guitar neck.
If your neck angle is not correct it is impossible to get low action or get rid of buzz. Normally people use cardboard, paper, wood or other things to shim the neck but this can take away sustain, putting a piece of brass between 2 pieces of wood actually increases sustain.
Easy Installation And Operation:
-
Remove neck by taking out the screws at the back
-
Place the smallest size shim at the back of the pocket if your neck was angled too far forward, at the front of the pocket if your neck was angled too far back
-
Put the neck back on and look down the neck from the body, Preferably you want it angled back ever so slightly, increase the shim size if there is not enough angle, ideally you want a -1 angle
-
If using the large size shim, use smaller sizes next to it to create a gradual slope and eliminate air gaps