CH-208 92 in 1 Multifunctional Test Car Maintenance Universal Junction Box
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
CAR2534
Bob Shop ID
596638587
1. When testing the components, without damaging the circuit, it can be adjusted directly from the rear of the harness plug terminal to reduce the damage of the circuit insulation rubber, thereby reducing the increase in impedance caused by the rust of the circuit.
2. Applicable to any electric meter, oscilloscope probe extension cord, reducing the trouble of wiring when checking the line, and helping you to quickly detect.
3. When measuring the current, there is no need to short or pull the wires apart, and the connection of the wire group can be used to achieve a series loop.
4. Equipped with two sets of LED lights, it can monitor the control signals of actuators such as Hall, photoelectric signals, fuel injectors, solenoid valves, and automatic transmission shift solenoid wires.
5. SRS replaces resistors, which can simulate airbags and seat belt tensioners to avoid accidents and misjudgments during maintenance.
6. Packing list:
- 5K Ohm variable resistor x 2
- LED stroboscope x 2
- Airbag system connector x 2
- 1 to 2 connector x 2
- Adapter 1 pair 1 x 4
- Needle probe x 4
- Alligator clip x 2
- Round terminal x 24
- Flat terminals x 48
- Probe x 2
2. Applicable to any electric meter, oscilloscope probe extension cord, reducing the trouble of wiring when checking the line, and helping you to quickly detect.
3. When measuring the current, there is no need to short or pull the wires apart, and the connection of the wire group can be used to achieve a series loop.
4. Equipped with two sets of LED lights, it can monitor the control signals of actuators such as Hall, photoelectric signals, fuel injectors, solenoid valves, and automatic transmission shift solenoid wires.
5. SRS replaces resistors, which can simulate airbags and seat belt tensioners to avoid accidents and misjudgments during maintenance.
6. Packing list:
- 5K Ohm variable resistor x 2
- LED stroboscope x 2
- Airbag system connector x 2
- 1 to 2 connector x 2
- Adapter 1 pair 1 x 4
- Needle probe x 4
- Alligator clip x 2
- Round terminal x 24
- Flat terminals x 48
- Probe x 2