R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable. Check my rate
Free collection
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 4 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
Main centres:
1-3 business days
Regional areas:
3-4 business days
Remote areas:
3-5 business days
Collection
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
TCCP016
Bob Shop ID:
603491359
TorkCraft - Chassis Screw Sheet Metal Punch. Size: 16 mm. Application: The Tork Craft Chassis Screw Sheet Metal Punch is a hand tool used to punch a. hole through sheet metal. It is a very simple tool that consists of a punch, die. and screw. To set up the punch, first drill a pilot hole into a piece of sheet metal with a. step drill bit, place the die over the draw stud before inserting the stud. through the pilot hole. The punch is then threaded onto the tip of the draw stud. and brought close to the sheet metal. For cutting clean holes fast. Cut into sheet metal up to 1.625mm mild steel. Also for industrial use. WARNING: Using any tool can be dangerous. Always select. the right tool for the job.
