Chassis - screw - sheet metal punch 16mm

Chassis - screw - sheet metal punch 16mm

151 available / new
R107.14
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Seller
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
TCCP016
Bob Shop ID
638922331
TorkCraft - Chassis Screw Sheet Metal Punch

Size: 16 mm

Application:

The Tork Craft Chassis Screw Sheet Metal Punch is a hand tool used to punch a hole through sheet metal. It is a very simple tool that consists of a punch, die and screw.

To set up the punch, first drill a pilot hole into a piece of sheet metal with a step drill bit, place the die over the draw stud before inserting the stud through the pilot hole. The punch is then threaded onto the tip of the draw stud and brought close to the sheet metal.

  • For cutting clean holes fast
  • Cut into sheet metal up to 1.625mm mild steel
  • Also for industrial use
WARNING: Using any tool can be dangerous. Always select the right tool for the job.
Add to cart

Recently viewed

See more
Bunty's Beach Towel 0700 - Design 074 - 100X164cms - 722GMS
R466.00
Electric Cordless Hair Straightener and Curling 2 In 1 Dry Comb Green
R384.00
2523000Q0J Engine Radiator Cooling Fan Control Module Relay for KICKS SENTRA Fan Resistors 2523000Q0
R511.00
Left Rear Door Lock Actuator Central Control Lock Car Door Lock for 931-108 15785128 15896626 258734
R692.00

Similar products

Tork Craft - Chassis - Screw - Sheet Metal Punch 25.4mm - 2 Pack
R505.00
18% OFF
Ruwag Drywall Screw Coarse Thread 3.5x16mm (100)
R49.00 R60.00
Chassis - screw - sheet metal punch 25.4mm
R228.66
Ruwag Drywall Screw Coarse Thread 3.5x16mm (25)
R19.00