Crankshaft Sensor Mazda Etude 323 Demio 1.3 1.5 1.6 – CRA055

Vehicle Fitment & Part Details

Crankshaft Sensor Mazda Etude 323 Demio 1.3 1.5 1.6 for the Mazda Etude VI (BJ) 1.6 ZM. Confirm compatibility by matching the listed fitment details, any OEM reference numbers supplied, and VIN/engine/chassis information where variants exist.

Part Type

Crankshaft Position Sensor (Inductive)

Brand

CRA

SKU

CRA055

Primary Fitment

Mazda Etude VI (BJ) 1.6 ZM

OEM Reference

ZL0118221 · ZL0118221A · FSD18221

Key Benefits

• Direct OEM-equivalent replacement matches original connector shape and pin configuration for plug-and-play installation.
• Inductive sensor design delivers reliable crankshaft position readings across the full RPM range.
• 340 mm cable length ensures a clean routing path to the engine harness without extensions.

Product Specifications

Vehicle Fitment

OEM Cross-References

Fitment Notes

This crankshaft position sensor fits the Mazda B-series engines used across the Etude, 323, and Demio platforms from 1998 to 2004. The rectangular 3-pin connector plugs directly into the factory harness. Always verify your engine code (B33G, ZL05/ZL06, B33L, or B5 E) before ordering to confirm compatibility.

Installation / Use / Maintenance Tips

• Always match OEM reference number(s) and vehicle details before ordering. Confirm exact fitment using VIN, engine code, or chassis number if multiple variants exist.
• Disconnect the battery before removing the old sensor to protect the ECU.
• Clean the sensor mounting surface on the engine block to ensure a correct air gap.
• Route the 340 mm cable away from exhaust components and secure it with the original clip to prevent heat damage.
• After installation, clear any stored fault codes with a diagnostic tool and verify the signal with a test drive.

Common Questions

Will this crankshaft sensor mazda etude 323 demio 1.3 1.5 1.6 fit my Mazda Etude?
This part (CRA055) is listed for the fitments shown on this page. Confirm by matching the fitment details and verifying VIN/engine/chassis information where variants exist.

What are the symptoms of a failing crankshaft sensor?
Intermittent stalling, hard starting, engine misfires, or a no-start condition are the most common signs. A stored P0335 or P0336 fault code usually confirms the diagnosis.

Is this sensor the same for the 1.3 and 1.5 engines?
Yes the same CRA055 sensor fits both the 1.3 (B33G/B33L) and 1.5 (ZL05/ZL06/B5 E) engines across the Etude, 323, and Demio range.

How do I confirm fitment if there are multiple variants?
Use VIN, engine code, and chassis/platform details and compare them to the fitment section above. If unsure, request fitment assistance before ordering.