CT 3.5-Inch 480x320 TFT 50FPS Touch Screen for Raspberry Pi

Please Note: The latest 64-bit distributions of operating systems, as well as Raspberry Pi OS Bookworm are not supported by the official driver for this display. You will need to make use of 32-bit Bullseye.

The Graphic driver is provided and can be downloaded for Raspberry Pi OS/Raspbian. It also supports Ubuntu and Kali Linux. Do follow the steps here: http://www.lcdwiki.com/MHS-3.5inch_RPi_Display

Features

• 3.5-inch TFT LCD screen with high-speed SPI interface
• Compatible with the latest Raspberry Pi 4 Model B
• Graphic drivers can be installed from Github, please refer to the steps here
• Support Raspberry Pi OS/Raspbian, Ubuntu, and Kali Linux Operating System
• Match perfectly with the 3.5-Inch Touch Screen ABS case (not included)
• Comes with 2-pin 5V and GND header to power a cooling fan.
• 3.5 inches LCD Spec:
  • Screen Type: TFT
  • LCD Driver : ICILI9486
  • Touch: Resistive Touch Control
  • Touch Controller: XPT2046
  • Resolution: 480 * 320
  • Refresh Rate: 50Hz
  • Interface: SPI (Input 125MHz)
  • Backlight: LED
  • Backlight Current: 120mA
  • Power: 5V
  • Operating Environment: -20 ~ 70 ℃
  • Size: ~ 89 x 60 x 30mm/3.5 x 2.36 x 1.18"

Installing the graphic driver for the LCD on the Raspberry Pi 4 Model B:

1. Please get a microSD card with the latest NOOBS/Raspberry Pi OS/Raspbian, or update the OS.
2. Stack the LCD onto Raspberry Pi, before the graphic driver is installed, the Raspberry Pi will output graphics to an HDMI port, so you will need a monitor, mouse, and keyboard to access the terminal.
3. Access to Raspberry Pi OS through the terminal or SSH too.
4. Install the graphic driver into Raspberry Pi OS
5. Execute the following command:
   1. sudo rm -rf LCD-show
   2. git clone https://github.com/goodtft/LCD-show.git
   3. chmod -R 755 LCD-show
   4. cd LCD-show/
   5. sudo ./MHS35-show
6. After this command, the Raspberry Pi will restart and the graphic will be displayed on 3.5 LCD instead of HDMI port.
7. The touch screen works without any special driver, as we tested on the latest Raspberry Pi OS (30 July 2020).
8. For more details, please refer to this link: http://www.lcdwiki.com/MHS-3.5inch_RPi_Display