| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
The Constant Temperature units are approved for outdoor installation only.
HOW IT WORKS
This gas geyser will supply hot water to 2 showers simultaneously without any temperature fluctuation as what you get with a standard gas geyser.
The Constant Temperature Gas Geyser has a 2 way proportional valve that can regulate the gas/water ratio, adjusting the gas volume. It therefore can operate with a low water flow minimum of 5l/minute
Constant Temperature Gas Geyser has a temperature adjusting panel on the front cover for easy setting of required water temperature
Will also maintain the set temperature
Ignition is through 2 x type D torch batteries Use Duracell or Energiser
Once you have inserted the batteries and check all connections - push the on/off button
Set temperature. The same is applicable when you replace flat batteries.
Open hot water tap - the water pressure pushes the light weight magnetic floater up (same as the zero start geyser) activates the geyser by signaling to the electronic box that there is spark and that the gas solenoid valve must open the gas to the main burners.
The water will then heat up through the heat exchanger to your desired set temperature.
The proportional valve will then regulate the gas/water ratio to keep the water at a constant temperature. The proportional valve ensures optimum performance at reduced LPG usage.
Always consider the following!
Make use of a qualified gas installer
