DenTek Temparin Max - Lost Filling & Loose Cap Repair (5+ repairs)

Designed to repair with the same ingredients dentists use. This is a temporary remedy meant to replace a lost filling, cap, crown or inlay until you have a chance to visit your dentist and should only be removed by dental professional. Visit dentist within 48 hours of use.

• Instant pain relief
• One step formula
• Easy to apply
• Maximum strength
• Dentist recommended
• 5+ repairs
• Includes spade tool with applicator tip

Made in Italy

To replace a lost filling: Wash the cavity area with warm water and do not dry. Cut with spade tool or pinch a small amount of product from the vial, and roll into a ball between fingers. Slightly overfill the cavity with product and tamp into place with applicator tool tip. Close your teeth together, as if you were biting down on a piece of paper, and gently chew or grind on the replaced filling a couple times to create a comfortable bite. Use a moist cotton swab to remove excess product from around the area. Moisture will accelerate the set. This product will set softly in your mouth within a few minutes, but avoid chewing on the repair for 2-3 hours to allow the material to fully set. To secure loose crowns, caps, or inlays: Try the crown, cap, or inlay first to see if you can fit it accurately back onto the tooth surface. If you are not able to do so, or if remaining tooth is cracked, then do not proceed further. If the crown has a post attached to it or if there is tooth surface remaining inside the crown, this product may not adhere. Carefully rinse the tooth area and the inside of the crown, cap, or inlay with warm water, and do not dry. Cut with spade tool or pinch a small amount of product from the vial, roll into a ball between fingers, and place evenly inside the crown, cap, or inlay. Place the crown, cap, or inlay on the tooth and bite down, applying pressure to push into position. This product will begin to harden within a few minutes, but avoid chewing on the repair for at least 2-3 hours to allow the material to set. Use a toothbrush to gently clear any excess material from around the crown, cap,