This item has closed 2 buyers bought 2 items
View other items offered by XT Comp10348
DHT11 Humidity and Temperature Sensor for Arduino ***LOCAL STOCK***
New
R29.50
Closed
8 Jun 17 14:31
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 5 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Bob Shop ID
282946812
DHT11 – Humidity and Temperature Sensor
Specification:
- Dimension 28mm*12mm*10mm
- Main chip DHT11 huminity sensor
- Voltage: DC 3.5~5.5V
- Digital output
- Humidity Range: 20—95%RH
- Humidity accuracy: ±5%RH
- Temperature range: 0—50¿
- Temperature accuracy: ±2¿
Temperature and humidity measurements are a great addition to many hobby projects.The four-pin device uses a 1-wire protocol. It’s a snap to connect to your project, requiring VCC, GND, and a pull-up resistor on the single data line.Each sensor has a unique serial number.
This item is available in stock and is not drop shipped. This avoids delays, customs charges and extra VAT.