Digispark Pro Kickstarter Development Board USB Micro ATTINY167 Module
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615102248
Description:
?
1. Compatible with IDE 1.5 (OSX/Win/Linux)
2. Fully signed drivers and executable for easy installation
3. USB programming, USB device emulation, USB-CDC virtual serial port emulation
4. 16 MHz AVR MCU - using a true 16Mhz precision crystal
5. 16KB Flash Memory (14.5K+ after bootloader)
6. Serial over USB debugging and communication!
7. 14 I/O Pins (2 shared with USB)
8. I2C, true SPI, UART, LIN, and USI
9. ADC on 10 pins
10. 3 PWM Channels (which can be assigned to a selection of pins)
11. Power via USB, or External Source - 5v or 6-16v (automatic selection) ?
12. On-board button that can be used as a reset, program, or user button - or can be disabled
?to use that pin as general i/o - without changing the bootloader
13. On-board 150mA 5V regulator
14. Power LED and Test/Status LED (on Pin 1)?
15. User accessible solder jumpers to disable LEDs, and other features for lower power consumption
16. Two mounting holes.
17. Breadboard compatible pin out/spacing (the three side header pins are only for legacy shield support).
?
Package included:
?
1 x Digispark Pro Kickstarter Development Board
?
1. Compatible with IDE 1.5 (OSX/Win/Linux)
2. Fully signed drivers and executable for easy installation
3. USB programming, USB device emulation, USB-CDC virtual serial port emulation
4. 16 MHz AVR MCU - using a true 16Mhz precision crystal
5. 16KB Flash Memory (14.5K+ after bootloader)
6. Serial over USB debugging and communication!
7. 14 I/O Pins (2 shared with USB)
8. I2C, true SPI, UART, LIN, and USI
9. ADC on 10 pins
10. 3 PWM Channels (which can be assigned to a selection of pins)
11. Power via USB, or External Source - 5v or 6-16v (automatic selection) ?
12. On-board button that can be used as a reset, program, or user button - or can be disabled
?to use that pin as general i/o - without changing the bootloader
13. On-board 150mA 5V regulator
14. Power LED and Test/Status LED (on Pin 1)?
15. User accessible solder jumpers to disable LEDs, and other features for lower power consumption
16. Two mounting holes.
17. Breadboard compatible pin out/spacing (the three side header pins are only for legacy shield support).
?
Package included:
?
1 x Digispark Pro Kickstarter Development Board