Digital geyser/pool pump programmable timer

Switching times = 8 ON, 8 Off, up to 128 programmes in a week

Switching load = 20 Amps, 4600 Watts

Power supply 230V AC 50Hz

Accuracy = 1minute / month

Minimum Time Set: 1 minute

Backup battery = Rechargeable Ni-MH 1.2V, 100 Hours

Operating temperature = -10°C to +40°C

Additional info:

• 8 buttons for easy operation
• Large LCD display with real time display
• 24 hours and 7 days programming with reset function for switching loads up to 4600 watts
• Built-in rechargeable Ni-MH battery to maintain the real time clock and programmed times when there is a power failure
• Ideal for industrial uses, geysers, swimming pools, Security lights, Heaters and Air Conditioners

This MTD8 timer can accommodate appliance power ratings of up to 4,6kW.

This MTD8 timer fits Din rail DB - for other DBs, purchase an adapter

This MTD8 measures approx 84mm high, 43 to 57mm deep, and 34mm wide

Should you have a geyser or appliance with power rating greater than 4,6kW, use this MTD8 timer in conjunction with a relay (available from your electrical distributor) to avoid damage to the MTD8 timer

Tips:

At the top of the MTD8, connect black/neutral to 2 and red/live to 1.

Charge it for a few hours (it's easier to program before installation).

Also bridge 1 to 4 as per instruction manual.

Set the clock to 24hr mode - this will make programming ON/OFF times easier.

The live that feeds you timer on top has to be bridged to no.4 if your timer has the same diagram as above.

Your output will be no.5 to your geyser or lights etc. nothing goes into no.3 unless you want something else to switch on when no.5 switches off.