This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1849
Digital Sound Card I2s Hifi Dac Audio Card for Raspberry Pi 3b + 4b
New
R632.00
Closed
22 May 24 15:28
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613482375
The upgraded DAC chip adopts the higher-end PCM5122 chip of BB Company, adopts 25 interface and can adjust the volume and audio parameters through the 12C interface; supports 16 to 32-bit audio data format; distortion and dynamics are very ideas, support high 384kHz sampling rate, dynamic range 112dB, distortion -93Db. 120dB squelch signal-to-noise ratio (SNR) for soft up or down ramps and analog squelch with no pops operation.pcM5122 also integrates a negative charge pump, and the output does not need a DC blocking capacitor; 2.1vrms grounded center output; very good ability to suppress out-of-band noise. By supporting loads as low as 1k ohm, the PCM510XA can drive multiple products in parallel.The output port adopts gold-plated RCV dual terminals and gold-plated 35mm headphone jackThe isolated power supply design is adopted to isolate the Raspberry Pi power supply from the DAC part of the independent power supply, and the common ground of the magnetic beads does not interfere with each other, so as to get rid of the current noise.No soldering, it can be used directly by plugging in the expansion board, and the I25 interface is used to directly decode the digital to analog non-USB interface DAC methodAdded to provide status display for two-color Led, the red light is the DAC power indicator (the power is on normally), and the green light is the DAC working status light (on when working and decoding, off when stopped or not working), to better understand the working condition of the DACThe pcB board adopts high-grade gold-plated process and arc-shaped wiring to better ensure the impedance continuity of the signal and reduce the reflection and refraction of the signal.colour: blueMaterial: PCBPackage Contents:1 x Expansion Board1 x Screw PackOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.