Dip8 Double Op Amp Finished Board High Current Output Low Distortion
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
616140964
The OPA1622 is a dual, bipolar input, SoundPlus audio operational amplifier. The device features a low noise density of 2.8nV/Hz and a low THD+N of 119.2dB at 1kHz, while also driving a 32ohm load at 100mW output power.The OPA1622's high AC Power Supply Rejection Ratio (PSRR) and Common Mode Rejection Ratio (CMRR) specifications eliminate noise from the power supply and are perfect for portable audio applications. In addition, the device features a high output drive of +145mA/130mA for direct drive headphone.The OPA1622 supports a wide supply voltage range of 2V to 18V with a supply current of only 2.6m per channel.The output current of the general operational amplifier NE5532 OPA2604 is less than 50MA, and the output of OPA1622 is up to 145MA, which greatly increases the driving force, so that the circuit has better matching, lower output impedance, high and low level, dynamic and therefore very good performance.colour:greenMaterial:Metal + PCPackage Contents:1 * Amplifier boardOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.