This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1654
Similar products
Drillpro 10pcs 1/8 Inch Shank Spiral Ball Nose End Mill 22mm Cutting Length CNC Milli... (SIZE: 2MM)
New
R503.00
Closed
11 May 24 00:26
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612461059
SELECTED OPTION:
SIZE: 2MM
Description: Double Edge Milling Cutter? Engraving Bits Ball Nose End Mills Tool ? Specifications: Material: Steel End design: ball nose Shank diameter: 3.175mm Cutting edge diameter:?2mm or 2.5mm or 3.17mm? (optional size) Cutting edge length: 22mm/0.67 Total length: approx 39mm/1.53 Quantity: 10pcs(same size) ? Features: - Non stick cutter, tasteless, quiet, blade design, sharp - Clean, tidy, no burr - Spiral chip design, chip smooth, reduce heat - Applies to the relief process of sub GREE, PVC, density board, hard wood ? Operation: 1. For the design of portable and desktop woodworking engraving machine, can not be used in drill machine. 2. Smooth surfaces, such as wood, to avoid the processing of copper, iron and other metal and sand, stone and other non wood materials. 3. Use appropriate size clip. 4. Tool clamping, found that the cutter has a beating phenomenon, should immediately stop, repeat clip a few times to get the tool shank and fixture to get full contact, and then work. 5. Cutter handle and the clamping sleeve contact should be good, a tool shank must be fully inserted into the jacket, tighten firmly. ? Package included: 1 set x Double edge milling cutter ? More Details:
