DRV8825 Stepper Motor Driver with Small Heatsink DRV8825 Stepper Motor Driver with Small Heatsink
DRV8825 Stepper Motor Driver with Small Heatsink DRV8825 Stepper Motor Driver with Small Heatsink

DRV8825 Stepper Motor Driver with Small Heatsink

5 available / new
Only 5 left – grab it before it’s gone!
R92.00
Shipping
R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.
The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Seller
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
3DP-00152
Bob Shop ID
635498543
This product is a carrier board or breakout board for TI's DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet (1MB pdf) before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2.2 A output current per coil (see the Power Dissipation Considerations section below for more information).
Features:
  • Suitable for 8.2V~45V (between VMOT and GND for motor), and less than 2.2A (2A for A4988) steppers
  • Simple step and direction control interface
  • Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step (N/A for A4988)
  • Adjustable current control lets you set the maximum current output with a potentiometer, which lets you use voltages above your stepper motor's rated voltage to achieve higher step rates
  • Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay)
  • 45 V maximum supply voltage
  • Built-in regulator (no external logic voltage supply needed)
  • Can interface directly with 3.3 V and 5 V systems
  • Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout
  • Short-to-ground and shorted-load protection
  • 4-layer, 2 oz copper PCB for improved heat dissipation
  • Exposed solderable ground pad below the driver IC on the bottom of the PCB
  • Module , pinout, and interface match those of our A4988 stepper motor driver carriers in most respects.
Suggestion:
Arduino cnc Shield v3 Breakout Board
Add to cart

Recently viewed

See more
Round Brown Wicker Table Lamp
R350.00
Teaching Learning Dynamics 5Ed
R590.00
55% OFF
Space-Saving Multi-Layer Pants Rack Anti-Slip Adjustable Design for Clothes
R99.00 R220.00
Computer CPU RGB luminous Radiator 4 Fans+Remote Control
R951.00

Similar products

Stepper motor driver based on drv8825 incl heatsink drv8825
R98.92
Nema 42 1.8" Stepper Motor 200mm
R8,552.71
Nema17 Pancake Stepper Motor
R207.00
TWO TREES DM556 Stepper Motor Driver 2 Phase 5.6A for 57 86 Stepper Motor NEMA23 NEMA34 Stepper Moto
R643.00