This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1652
Similar products
DY-AP3015 DC 8-24V 30W x 2 Class D Dual Channel High Power Stereo Digital Amplifier Board with Adjus
New
R419.00
Closed
11 May 24 00:04
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612368143
Specification: ? Model: DY-AP3015? Working voltage: DC: 8~24V? Working mode: Class D (PWM modulation)? Number of channels: stereo (two channels)? Maximum output power (@1KHz):? 18W*2 @12V 4??? 10W*2 @12V 8??? 15W*2 @16V 8??? 20W*2 @20V 8??? 30W*2 @24V 8?? (requires heat sink)? Adapter speaker (30W~150W):? 4 ohms (8-12V power supply)? 8 ohms (8-24V power supply)? Module protection mechanism: reverse power protection? Short circuit protection: self-recovery overheat protection? ? Usage: ? 1. Recommended power supply voltage DC 8~24V, more than 26V, the chip will burn out, there will be noise below 8V.? 2. The power supply does not exceed 12V when connected to a 4?? speaker, and the power supply does not exceed 24V when connected to an 8 ohm speaker.? 3. The power supply current is recommended to be 2A or more.? 4. The module working power exceeds 20W*2, need to add heat sink? 5. Ensure that the input source signal is between 0.5V and 1.5V.? 6. The speaker cable should not be too long, to ensure that within 1 meter? 7. Pay attention to static electricity protection. Before touching the power amplifier board, you need to release the static electricity on your hand to avoid static electricity from penetrating the power amplifier chip. The digital power amplifier is sensitive to static electricity.? 8 It is recommended to use the speaker rated power 30W and above, to avoid the burning of the speaker. ? Package Included: ? 1 x DY-AP3015 30W x2 Stereo Amplifier Module
