Ecco 51.2v 100ah 5.12kWh Lithium Battery LiFePO4 48-100mb16 (Rack Mount)

Ecco 51.2v 100ah 5.12kWh Lithium Battery LiFePO4 48-100mb16

• Intra-system balancing
• Flame retardant system to UL94V-0
• Complete with Battery Management System built-in
• Built-in automatic protection for over-charge, over-discharge & over-temperature conditions
• Environmental Friendly, without any heavy metals
• Easy installation, can be in 19-inch standard cabinet or be wall-mounted
• Thousands of cycles, under normal conditions
• High energy density and conversion efficiency
• Good high temperature performance
• Low self discharge rate of 2 years before required recharging
• Safe Lithium Iron Phosphate Technology
• Can use most standard VRLA chargers for this system
• High cycle times and long service life

Longer Cycle Life: Offers up to 20 times longer cycle life and five times longer float/calendar life than a lead acid battery, helping to minimize replacement cost and reduce the total cost of ownership. Lighter Weight: About 40% of the weight of a comparable lead acid battery. A 'drop in' replacement for lead acid batteries. Higher Power: Delivers twice the power of the lead acid battery, even high discharge rate, while maintaining high energy capacity. Wider Temperature Range: -20 C~60 C. Superior Safety: Lithium Iron Phosphate chemistry eliminates the risk of explosion or combustion due to high impact, overcharging, or short circuit situations.

What's in the box:

1x Ecco 51.2v 100ah 5.12kWh Lithium Battery LiFePO4 48-100mb16

Battery cables included

Specifications:

Battery Parameters:

Battery Type is set to "USE."
Bulk Charge Voltage is set to 56.4-56.6V.
Float Charge Voltage is set to 54V.
Cut Off Voltage is set to 47V.

Charging Amps : 30A

Warranties:

5 Years Warranty
All inverters and batteries must be installed by a qualified electrical wireman or Master electrician with a valid registration with the Department of Labour. A valid electrical certificate of compliance (COC) must be issued once installed, specific to the installation of the backup or solar system. The installation must be compliant with SANS 10142 and ALL its parts. Any warranty claim submitted without installation photos, a valid COC and proof of a qualified wireman/master electrician installing the unit, can be rejected and will render the warranty claim null at void.