Electric Woodworking Carving Chisel Wood Carving Tool Set With 5 Cutter Head And Flexi... (SIZE: #2)

New

12 were available

R784.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3860

92.72 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

615093544

SELECTED OPTION:
SIZE: #2

Description: Electric Woodworking Carving Chisel Wood Carving Tool Set With 5 Cutter Head And Flexible Shaft For Electric Drill Electric Grinder ?
Specifications: Uses: woodworking Head type: Hex clamping nut Handle material: nylon Overall length: 160mm Flexible Shaft Connection Diameter: 6mm Suitable For: Electric drills, electric grinders.
? #2 1 x Electric chisel 1 x Flexible rubber shaft 5 x Cutter head 1 x Wrench ? Features: In addition to general wood, it is also possible to engrave ebony, soft plastic and so on. The casing is solid, the heat dissipation efficiency is excellent and safe. Mainly used for wood, furniture carving, antique floor carving, potted plants, toys, figures, animals and other sculptures. Each electric chisel is equipped with 5 special cutter heads and a small wrench. The new electric woodworking carving chisel, carving cutter instead of traditional hand-carving, saves time and effort. ? Tips: The electric chisel needs to be equipped with a hanging mill or a small table mill or a drill shaft. The shaft with a soft shaft can be used on a flexible shaft that can be removed. It cannot be used alone, and the motor speed should be less than 12,000 rpm. When using the engraving cutter it must be installed on the right side of the mill or the reverse direction will destroy the flexible shaft. With a 10-point hand, you must stop the 2-3 minute hand to avoid overheating the product. ? Notice: 1.Please allow 1-2mm error due to manual measurement.Please make sure you do not mind before you bid. 2.The colors may have different as the difference display,please understand. ? More Details: