ENC28J60 Ethernet module breakout board Arduino
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
MOD-051
Bob Shop ID
614719046
The cheapest but also a very easy way to add ethernet to microcontrollers like Arduino.
This module has an ISP interface for communication.
Head over to this link https://github.com/jcw/ethercard#readme to learn all about the ENC28J60 Ethernet module, download the library and get Arduino examples to use.
Note: it is important to connect this module to the 3.3V power pin and NOT 5V. 5V is to much power for this board and will damage it.
Pinout table
Module description
Chip ENC28J60-I/SO
25MHZ crystal oscillator
HR911105 JACK
3.3V pin header power jack
Dimension 56(mm) x 34(mm)