ENCNF2S-N01 NGFF To SATA3 Transfer Card M.2 KEY B-M SSD To 6Gbps Interface Conversion Adapter Wit...
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0603728103
Bob Shop ID
595737015
1. Connect the M.2 hard disk defined by KEY-B-M SATA on the motherboard to the SATA 22PIN interface. This adapter board only connects the signal from the M.2 hard disk to the SATA 22PIN connector, so the adapter card does not need a driver.
2. Support all SATA standard M2.SSD, do not support NVME M2.SSD, do not support PCI-E M2 SSD
3. This card is suitable for 4 different SSD hard disk lengths, suitable for different M2 (NGFF) SSD hard disk lengths such as 3cm, 4.2cm, 6cm, and 8cm.
Using ceramic filter capacitors, high-power LDO voltage regulator control chip, stable performance
The riser card only changes the interface form of the solid state drive, and does not change any performance of your hard drive. What are the parameters of your original hard drive, with the riser card, the performance of the output interface will not change.
Product interface: M.2 NGFF SATA 22PIN
Support system: WinXP/Vista/Win7/Win8 32-bit/64-bit MAC/LINUX
Note: The product is only a riser card, not including a hard disk