This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1654
Engine Oil Pan Sump Tank Heater 220~240V 250W Protection Reduce Wear EUR Plug
New
R507.00
Closed
11 May 24 00:21
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612441314
Feature:
1. Well waterproof performance, fast temperature rising, temperature uniformity,High thermal efficiency, well toughness
2. Conform to the American UL94 level V0 flame resistant standard
3. Easy to use, safe service life for ten years, not easy aging
4. With European standard plug
Specification:
Installation:
1. Use pressure-sensitive adhesive to stick it on the flat and smooth artifacts
2. The maximum service temperature of pressure sensitive adhesive: 150a?? Continuous temperature,
??? 230a??instantaneous temperature. Power density is less than 0.9 W/c ???
3. Silicone rubber heater with pressure sensitive adhesive should be used in half a year after processing,
??? otherwise it will influence on the performance of the glue using
Instructions:
1. The electric heating device must pay attention to use, its working temperature should be less than 240 a??,
??? the continuous use instantaneous does not exceed 300 a??.
2. When the work temperature less than 240 a??, the current density is up to 3 w/c ???
3. Paste the type installation conditions, allowed working temperature less than 150 a??
4. Working voltage selection with high power high voltage, low power low voltage for the principle,
??? special needs can be exceptions.
Package Included:
1 X Car Heater Tank
1. Well waterproof performance, fast temperature rising, temperature uniformity,High thermal efficiency, well toughness
2. Conform to the American UL94 level V0 flame resistant standard
3. Easy to use, safe service life for ten years, not easy aging
4. With European standard plug
Specification:
| ?Material | ?Silicone rubber + fiberglass cloth |
| ?Color | ?Orange |
| ?Voltage | ?220 V, 250 W |
| ?Using range | ?All kinds of automobile fuel tank, water tank, storage battery, ?anti-freezing heat insulation |
| ?Usage: | ?Product with double-sided adhesive on the back, ?can be directly stick on the heated products, the highest ?heat resistance temperature to 200a??, will never fall off |
| ?Size | ?9 x 13cm |
| ?Wire Length | ?210cm |
Installation:
1. Use pressure-sensitive adhesive to stick it on the flat and smooth artifacts
2. The maximum service temperature of pressure sensitive adhesive: 150a?? Continuous temperature,
??? 230a??instantaneous temperature. Power density is less than 0.9 W/c ???
3. Silicone rubber heater with pressure sensitive adhesive should be used in half a year after processing,
??? otherwise it will influence on the performance of the glue using
Instructions:
1. The electric heating device must pay attention to use, its working temperature should be less than 240 a??,
??? the continuous use instantaneous does not exceed 300 a??.
2. When the work temperature less than 240 a??, the current density is up to 3 w/c ???
3. Paste the type installation conditions, allowed working temperature less than 150 a??
4. Working voltage selection with high power high voltage, low power low voltage for the principle,
??? special needs can be exceptions.
Package Included:
1 X Car Heater Tank