This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1659
Similar products
ESP32 ESP32S 18650 Battery Charge Shield V3 Micro USB Type-A USB 0.5A Test Charging Protection Board
New
R375.00
Closed
11 May 24 00:03
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
612367930
Note: ? This module is suitable for 18650 battery only This module can be powered or for raspberry pi and sensor at the same time This module output current up to 2A
(This product does not contain 18650 battery installation,?be careful of?the battery positive and negative when install, do not reverse. Please follow the + - direction on the PCB and do not follow the positive and negative directions on the battery holder) ? Features: ? 1. With over-charging protection and over-discharge protection 2. Micro USB charging interface 3. Charge current: 0.5A 4. 1 switches to control the USB output 5. Input voltage: 5 ~ 8V 6. Three 3V 1A output interface? 7. Three 5V 2A output interface 8. LED light, green for full of charge, red for under charging ? Package includes: ? 1 x 18650 Battery Charging Protection Board
(This product does not contain 18650 battery installation,?be careful of?the battery positive and negative when install, do not reverse. Please follow the + - direction on the PCB and do not follow the positive and negative directions on the battery holder) ? Features: ? 1. With over-charging protection and over-discharge protection 2. Micro USB charging interface 3. Charge current: 0.5A 4. 1 switches to control the USB output 5. Input voltage: 5 ~ 8V 6. Three 3V 1A output interface? 7. Three 5V 2A output interface 8. LED light, green for full of charge, red for under charging ? Package includes: ? 1 x 18650 Battery Charging Protection Board