ESP32 ESP32S 18650 Battery Charge Shield V3 Micro USB Type-A USB 0.5A Test Charging Protection Board

New

20 available

R375.00

Add to watchlist Watch

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3807

92.85 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Product details

Condition

New

Location

International

Bob Shop ID

648367436

Note: This module is suitable for 18650 battery only This module can be powered or for raspberry pi and sensor at the same time This module output current up to 2A
(This product does not contain 18650 battery installation,be careful ofthe battery positive and negative when install, do not reverse. Please follow the + - direction on the PCB and do not follow the positive and negative directions on the battery holder) Features: 1. With over-charging protection and over-discharge protection 2. Micro USB charging interface 3. Charge current: 0.5A 4. 1 switches to control the USB output 5. Input voltage: 5 ~ 8V 6. Three 3V 1A output interface 7. Three 5V 2A output interface 8. LED light, green for full of charge, red for under charging Package includes: 1 x 18650 Battery Charging Protection Board