ESP32S IoT Kit- Simplifying IoT with V ONE

If you are looking for a kit with everything to get started with IoT, this is just the kit for you. This kit has the ESP32S development board that is used to process the input received from the sensors to have useful data to use as output to control a system. Because this module has a Bluetooth and Wi-fi antenna on the module and a connector for an external antenna for better range, it can easily connect to your Wi-fi to control the system manually from another device that is connected to the same network. The kit comes with different sensors that can be used with this ES32-S module as input and various LEDs and a motor that can be used output.

What is in the kit?

1 x NodeMCU-ESP32-SWi-fi Bluetooth BLE IoT DEV board

1 x Moisture sensor module

1 x 1CH active H/L 3V Octo Coupler relay module

1 x 300C 1.5-6V DC 7mm shaft motor

1 x DIY four blades 56mm motor propeller

1 x Pind diagram card for NodeMCU-ESP32S

1 x Registration card for free V-ONE account

1 x Micro USB B cable

1 x Breadboard

1 x DHT11 Sensor

1 x Rain sensor

1 x MQ2 smoke sensor

2 x Infrared sensor module

1 x SG90 micro servo

2 x Push button

1 x Red LED

1 x Yellow LED

1 x Green LED

3 x Resistors 220 Ohm 0.25W

20 x Male to female jumper wire

20 x Male to male jumper wire

1 x Multi tip screwdriver