ESP8266 ESP-01 ESP-01S WS2812 RGB LED Lamp Module Support for IDE Programming Geekcreit for Arduino
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615102545
.size_table_start table,.size_table_start table tr td { border:2px solid #ddd;}.size_table_start table { width: 100%; min-height: 25px; line-height: 25px; text-align: center; border-collapse: collapse;}.size_table_start,.size_table_end {clear:both;}
Feature:
This is a WS2812 RGB LED control module based on ESP-01 / 01S. With it, you can easily control the WS2812 light bar / light ring. DIY own lighting control system. Support for Ard uino IDE programming. ? Characteristic:
* Master: ESP-01 / ESP-01S (This module does not include ESP-01 / ESP-01S) * Control Pin: GPIO2 * Interface: 3Pin PH2.0 connector * Operating Voltage: DC 3.7V-5V (Please note: The positive supply voltage VCC on the board is connected to the VCC on the WS2812 3PIN connector. Therefore, if your light bar/lamp ring is 5V powered, use DC 3.7V-5V power supply.) * Support 3.7V lithium battery ?? Application example:
1. Power supply: 3.7V-5V DC power supply to the VCC GND (2.54mm pin) 2.Download the program to ESP-01S 3. Insert the ESP-01 / ESP-01S into the 2 * 4 Pin header (in the direction of the arrow) as shown below:
Package includes:
1 x ESP-01S RGB LED module (NOT include ESP-01S WiFi module and RGB LED) 1 x 3PIN PH2.0 connector
This is a WS2812 RGB LED control module based on ESP-01 / 01S. With it, you can easily control the WS2812 light bar / light ring. DIY own lighting control system. Support for Ard uino IDE programming. ? Characteristic:
* Master: ESP-01 / ESP-01S (This module does not include ESP-01 / ESP-01S) * Control Pin: GPIO2 * Interface: 3Pin PH2.0 connector * Operating Voltage: DC 3.7V-5V (Please note: The positive supply voltage VCC on the board is connected to the VCC on the WS2812 3PIN connector. Therefore, if your light bar/lamp ring is 5V powered, use DC 3.7V-5V power supply.) * Support 3.7V lithium battery ?? Application example:
1. Power supply: 3.7V-5V DC power supply to the VCC GND (2.54mm pin) 2.Download the program to ESP-01S 3. Insert the ESP-01 / ESP-01S into the 2 * 4 Pin header (in the direction of the arrow) as shown below:
Package includes:
1 x ESP-01S RGB LED module (NOT include ESP-01S WiFi module and RGB LED) 1 x 3PIN PH2.0 connector
