Name: Float Valve 1/2 BSP Automatic Water Level 90deg **LOCAL STOCK**
SKU: SEN163
Price: 150.00 ZAR
Availability: InStock

Float Valve 1/2" BSP Automatic Water Level 90deg **LOCAL STOCK**

4 available / new

Only 4 left – grab it before it’s gone!

R150.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Diy Select - Cape Town8401

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

SEN163

Bob Shop ID

640268829

1/2" BSP Sensor Float Switch Water Fluid Level:

Specifications:

Material: Nylon PA66 + Food grade rubber
Applicable Medium: Clean Water
Work Pressure: 1-10KG (0.1-1MPa)
Rated Temperature: 0-60°
Size: 126 x 57 x 56mm

1. Automatic control
2. Easy installation
3. No need extra power supply

An ideal valve to replace the traditional float switch, it is widely used for various systems of water tanks, water towers of the industry and civil construction, automatic shut-off for swimming pools, chicken coops, automatic chicken water drinker, cattle watering drought, rain collection barrels in the outdoors etc..

When installed, the float must be vertical. A float valve inside allows water to flow until a specific level is reached. Once the water reaches this level, the float valve will be pushed up with water due to buoyancy and stop the flow of water. When the water level starts dropping, the valve will open again, and the water will start to flow again.The float valve works with 10 to 150 psi water pressure, if water pressure is too low or too large, the float valve will not suitable for using, it will not work or be damaged.

The float valve comes with filter, the filter must be used in the water inlet, avoid sand, stone or any debris from blocking the floating ball.
If you are using an automatic fill float of any kind indoors, please make sure you have an emergency overflow system in place. Auto fill floats of any kind can eventually malfunction and cause flooding. It's always best to set the lowest flow of water needed to maintain a full water level.