Flywheel Locking Tool with 36mm 3/4 Inch Wench for 6.6l Duramax 3pcs
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 12 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
616194512
Pros -- Locks the flywheel in place when removing the harmonic balancer on a 6.6L Duramax engine with an automatic transmission. Less time-consuming than removing the starter.Use the sprockets to remove only the metal spring load check plate on the bottom of the derailleur. The tool should slide into the engine opening with the top of the tool touching the teeth of the flywheel.Remove the rubber access cover on the bottom of the derailleur using the block with screws. Insert the tool into the front of the opening and tighten the flywheel to hold the tool in place.36mm Sockets -- to use a 36mm 3/4inch square driver, remove the harmonic balancer bolts and re-torque when installing.Material:Metalcolour:BlackPackage Contents:3 x Flywheel Locking ToolOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.