for 1/10 94123 94111 Parts 102010 102011 102012 Ball Bearing Aluminum Alloy Steering Hub Mount Set
New
20 were available
R460.00
0% off
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 12 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
Replacement Guarantee:
7 Days: We stand by this guarantee
Get it now, pay later
Product details
Condition
New
Location
International
Bob Shop ID
653979830
General back-pressure cooling pipe materials are aluminum alloy because of good heat dissipation.When the exhaust gas through the back pressure after the cooling tube, you can make the gas into the tank cooler, then the fuel temperature is naturally not so high.So you can make the engine slightly lower the temperature on hand can increase the engine's life slightly, on the other hand can make the engine operating temperature is reduced, but also took a box of run a few minutes more effectColour:PurpleMaterial:MetalPackage Contents:2 * RC Car rear axle 2 * RC Car front steering cups2 * RC Car door 8 * RC Car Only the above package content, other products are not included.Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.
