For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg
For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg
For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg
+3

For DJI Mavic 4 Pro CQT 4 In 1 Height Increasing Landing Gear Support Leg

New 10 available
R258.74
Want to pay less?
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 15 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Seller
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
International
Product code
TBD0606113301
Bob Shop ID
651678046

1. Protect the tripod and prevent wear
2. It can be raised by about 5mm after use and can be placed in the storage bag without disassembly
3. With adhesive, it can be used repeatedly without leaving residual adhesive and without damaging the fuselage
4. Before installation, please be sure to clean the contact surface between the aircraft and the tripod. If there is dust or impurities, it is easy to stick and cause the tripod to fall off; please press hard to install
5. Material: plastic
6. Weight: about 8g
7. Size: about 2.5 x 4.5 x 1cm
8. Note: only the tripod is included, nothing else is included

Add to cart

Similar products

Don't miss out on the latest deals!