For DJI Mini 3 / Mini 3 Pro 1pair Height Increase Kickstand Landing Gear Propeller Protective Cover
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD06044581
Bob Shop ID
608685436
1. Reduce the wear and tear of the tripod and chassis, effectively increase the height by 25mm, prevent scratching the fuselage and gimbal, and can still take off and land under uneven ground conditions
2. Lightweight and stable frame, can stably carry the fuselage, almost does not affect the flight and endurance
3. Can be used as a mirror to the end of the bracket, handheld takeoff and landing
5. Triangular reinforcement design around the perimeter for more stable support
6. Front and rear use snap-on independent mounting, stable hook front and rear arms, stronger force, more stable
7. The tripod is designed to lie on the outside, 90 degrees downward shooting will not shoot the tripod
8. Easy to install, quick release and quick install, pay attention to differentiate the tripod serial number
9. Weight: about 21.8 grams
10. Size: about 14 x 7.9 x 1.9cm
11. Note: shipment includes only 2 tripods, does not include the demonstration drone
Installation steps:
1. Hook the booster leg (R1) onto the right front arm
2. Hold the kickstand and gently push the rear right arm forward, then hook the kickstand (R2) backward
3. Install the left side booster leg as the right side to complete the installation