Front Rear Lights Motorcycle LED Strip Flexible Signal Light Indicator Ring w/ C... (COLOR.: YELLOW)

New

12 were available

R359.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3807

92.85 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

615177684

SELECTED OPTION:
COLOR.: YELLOW

for more options in this item.

Description: With controller, burst flashing could be adjusted. Excellent quality guided light Turn signals. Waterproof and long lifespan. High light LED, provide eye-catching show off and personlise your motorcycle. ? Specification: Product Name: Motorcycle Ring LED Turn Signals Voltage: 12V Application: 40mm-80mm/ 1.57 - 3.15 Diameter Light Color: White/ Blue/ Red/ Yellow Size: 25cm x 1.5cm/ 9.84 x 0.6 (Length x Width) Placement on Vehicle: Front Quantity: 1 PC ? Installation Methods: 1. Clean the location of the installation with rubbing alcohol before proceeding.
(Make sure to remove any grease, wax or dust etc.) 2. Please ensure that the product completely fits before proceeding with installation.
(Note: If there any questions or if the product does not fit properly, please contact us.) 3. Remove the high strength double-sided adhesive from the back.
In the case of a relatively low temperature, heat installation location,
and plate with a hair dryer or a heat gun on low setting. 4. Carefully place the product in desired location and press down for about 1-2 minutes,
(Note: Do not wash your car for 24-hour. The adhesive should be cured after 12-hour.) 5. The installation is completed. ? Note: 1.We provide clear pictures, measurements where possible.
Please check as much as possible to make sure the item is the one that you need. 2.Please allow 0.5-1 inch difference due to manual measurement. (1inch=2.54cm) 3.Installation Instructions is not included. Professional Installation Is Highly Recommended! 4.The color of the actual items may slightly different from the listing images
due to different computer screen, thanks for your understanding. ? Package Included: 1 X Motorcycle LED Ring Turn Signal Light