Front Right ABS Wheel Speed Sensor for 2006-2010 Explorer 6L2Z2C204A Practical

Wheel speed sensor wiring bracket is mounted to the control arm and the bottom plate of the vehicle.Wheel speed sensor is mounted to the steering knuckle. After the wheel speed sensor wiring bolts to 10lbf ft stent (16N-M), the festival will turn to tighten the fixing bolt to 16 LBF-FT (22Nm).Wheel speed sensor wiring connector pass through the hole in the floor, and the joint wiring connector connect again after receiving the suspension, tighten the plastic clip.Check the wheel speed sensor gap: (1) Check whether there is damage to the wheel pulse signal generator with the teeth. (2) Rotating drive shaft with Hand, measuring space between wheel speed sensor and a pulse generator wheel. shaft is to rotated a circle, check the gap. The standard clearance is 0.02-0.04in (0.5-1.0mm). (3) If the space exceeds the standard value, check the steering knuckle and pulse generator wheel have been out of shape.Install the rear wheel and fall under the vehicle.To tight the wheel nuts to 80 LBF-FT (110N-M).Picking up the battery negative connection.Turn the ignition switch to \on\ (open) position, but do not start the engine. Open the anti lock system indicator. Start the engine and check whether the indicator closed. If the engine rotates, flashing lights, is not bright or not, it must be diagnosed about fault of system.To install the trunk lid .Specification:Replaceable part number: 6L2Z2C204AApplicable models: for 2006-2010 Explorerfor 2006-2010 Mercury MountaineerColour:blackMaterial:ABSPackage Contents:1 * Speed SensorOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +\/- 1-3cm.