Front Upper Strut Mounting with Bearing for Hyundai Veloster 1.6 and Elantra AR9127

SKU: AR9127
Part type: Front upper strut mounting with bearing

OE Reference Numbers

This front upper strut mounting with bearing is referenced against the following Hyundai OE numbers as supplied:

• Hyundai: 546103X100, 546103X200

Matching the OE number on the original strut top mount to these references helps confirm fitment and supports accurate selection at the counter and in the workshop.

Vehicle Compatibility

The applications below are based only on the vehicle information and catalogue lines you provided.

Hyundai Veloster

• Hyundai Veloster 1.6, front upper strut mounting with bearing, from 2013

Hyundai Elantra

• HYUNDAI ELANTRA 1.6 [MD, engine code G4FG, year range 2011 to 2017
• HYUNDAI ELANTRA 1.8 [MD, engine code G4NB, from 2011

Always confirm the vehicle details, engine code and OE number on the original component against this information before supplying or fitting the part. This helps reduce comebacks and supports trust between the workshop and the customer.

Product Overview

AR9127 is a front upper strut mounting with bearing listed for selected Hyundai Veloster 1.6 and Hyundai Elantra models. The strut top mount supports the upper part of the MacPherson strut assembly while the integrated bearing allows the suspension to rotate smoothly when steering.

A worn or noisy strut mounting can affect steering feel, create knocking sounds over bumps and lead to uneven suspension behaviour. Using a part that is correctly referenced to the specified Hyundai OE numbers and to the catalogue data supplied gives workshops and spares outlets additional confidence in the application.

This component is suitable for everyday road use in South African conditions and is aimed at professional repairers, parts counters and informed vehicle owners who rely on catalogue correct information and dependable service.

Fitment Guidance

• Confirm that the original strut top mount corresponds to Hyundai OE 546103X100 or 546103X200.
• Check that the vehicle is a Hyundai Veloster 1.6 from 2013 or a Hyundai Elantra 1.6 or 1.8 in the model ranges listed above.
• Verify engine codes such as G4FG and G4NB where applicable to support accurate part matching.
• Inspect the existing strut assembly for damage, corrosion or leaking shock absorbers before refitting with the new mount.
• Always replace in axle pairs where workshop practice or local policy requires it to maintain balanced suspension performance.

Installation and Maintenance Tips

• Support the suspension safely and follow workshop manual procedures when removing the front strut assemblies.
• Use an appropriate spring compressor to remove the old mount and bearing from the strut and to install AR9127.
• Inspect the coil spring, bump stop and dust cover while the strut is removed and replace any worn components at the same time.
• Ensure the bearing side of the mount is oriented correctly according to the strut and body locating features.
• Tighten the upper and lower strut fasteners to the specified torque values in the vehicle repair information.
• After refitting, a wheel alignment check is recommended, especially if suspension components have been disturbed.
• Listen for any unusual noises on the test drive and recheck critical fasteners once the vehicle has settled.

Delivery Information

AR9127 is supplied for the South African market with nationwide delivery available to major centres such as Johannesburg, Pretoria, Durban and Cape Town, as well as surrounding regions. This supports workshops and spares distributors that depend on consistent access to front suspension components referenced to correct OE numbers.