Front Wheel Speed Sensor (Left or Right) for VW Golf 4, Jetta 4 & Audi A3

Vehicle Fitment & Part Details

This front wheel speed sensor is listed for the VW Golf 4 1.6i (AKL) and cross-references VW OE 1J0 927 803 (left) / 1J0 927 804 (right). This listing covers both left and right positions select the correct side for your vehicle using the comparison table below. Confirm compatibility by matching the listed fitment details, any OEM reference numbers supplied, and VIN/engine/chassis information where variants exist.

SKU Comparison Select Left or Right

Select the correct side: MAP-101032 is the front left sensor; MAP-101033 is the front right sensor. Match the OE reference number on the removed sensor to confirm which side you need. On SA right-hand-drive vehicles, front left is the nearside (passenger) and front right is the offside (driver) position.

Key Details

SKU (Left)

MAP-101032

SKU (Right)

MAP-101033

Component

Wheel Speed Sensor

Position

Front Left (MAP-101032) / Front Right (MAP-101033)

Primary Fitment

VW Golf 4 1.6i (AKL) (19992004)

Key Benefits

• Both left and right sensors available on a single listing select the correct side using the comparison table above.
• VAG group OEM reference numbers listed across Audi, Seat, Skoda and VW for cross-checking before ordering.
• Covers 27 supplied applications across VW Golf 3/4, Jetta 3/4, New Beetle, Audi A3, S3, and TT.

OEM Reference Numbers

Vehicle Fitment

Includes 27 supplied applications. Fitment applies to both left (MAP-101032) and right (MAP-101033) sensors.

Fitment Notes

• Always match OEM reference number(s) and vehicle details before ordering. Confirm exact fitment using VIN, engine code, or chassis number if multiple variants exist.
• This listing covers both front left and front right select the correct side. On SA right-hand-drive vehicles: front left = nearside (passenger), front right = offside (driver).
• The left sensor (MAP-101032) crosses to 1J0 927 803 and 1H0 927 807. The right sensor (MAP-101033) crosses to 1J0 927 804. Match the OE number on the removed sensor to confirm which side you need.

Installation / Use / Maintenance Tips

• Compare the new sensor to the removed unit match connector type, cable length, and mounting bracket before fitting.
• Clean the sensor mounting bore in the hub carrier and inspect the ABS reluctor ring/tone wheel for damage, debris, or missing teeth before fitting the new sensor.
• Ensure the sensor seats fully and squarely in the mounting bore incorrect air gap will cause ABS faults.
• After installation, clear any stored ABS fault codes with a compatible diagnostic tool and verify correct operation with a short road test.

Common Questions

How do I know if I need the left or right sensor?
Check the OE reference number on the removed sensor. 1J0 927 803 or 1H0 927 807 = front left (MAP-101032). 1J0 927 804 = fron...