Geekcreit DIY Biaxial Spherical Rotating DIY LED Flash Kit Creative POV Soldering Training Kit

20 available / new

R777.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3463

93.47 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

641124867

Introduction:

New version of Biaxial Spherical Rotating.
Part of rotary plate are using high-power wireless power supply, rotating noise greatly reduced.
System power supply voltage 12V2A (please use your own power), rotating motherboard using STM8S105K4T6 single-chip control, plug-in 8 Mbit flash storage text, pictures, animation!
Through the host computer software to send text, pictures, animation, calibration time, PC software support Chinese and English input.
Clock chip using DS1302 with backup battery, support the remote control to adjust the time. Remote control switch a variety of display modes, to provide some open source C program, suitable for learning purposes.

Note:

This is a DIY kit, you need to have some electronic knowledge and ability. SMD is unsoldered!!
The kit has certain difficulty, please buy according to your own situation.
Don't comes with TTL serial downloader.
Dual a xis of each 56 LEDs display.
Motor speed is high, no shell, please be careful to use!
Red light / blue light can be soldered according to personal preferences in the inner and outer ring.

Hardware parameters (error 2mm):

Acrylic board: 16.2 * 16.2cm
Main control board: 12.5 * 4.8cm
Side panel: 9cm high / 7.5cm high
Finished product reference height: 11cm

Package includes:

1 x DIY Spherical Rotating LED Kit