H-Bridge Stepper Motor Dual DC Driver Board for Arduino - L9110S
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
567
Bob Shop ID:
612190915
H-Bridge Stepper Motor Dual DC Driver Board for Arduino - L9110S
Product Description
There are two L9110S motor control chip onboard, This module can simultaneously drive two DC motors or a 4-wire 2-phase stepper motors.
Product Features
- Work under low static current
- Power supply voltage: DC 2.5V - 12V
- Each channel has 800mA continuous current output
- Low saturation pressure drop
- TTL / CMOS output level compatible, can be connected directly to the CPU
- Output built-in clamping diode, apply to the perceptual load
- Control and drive integrate in IC
- Pin high pressure protection function
- Working temperature: 0C - 80C
- Size: 29 x 21mm(L x W)
Please note: Locally Stocked, Available for Immediate Shipping!